hestan KIC Serie Manuel D'utilisation Et D'entretien page 19

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

USER INSTRUCTIONS
TIMER FUNCTION
TIMER FUNCTION
NOTE: the timer is only intended as an acoustic advisor that recalls the attention of the user.
Timers have no effect on the heating elements. Cooking zones must always be stopped
manually by touching the corresponding [OFF] key.
There are two versions of the timer function:
An independent timer from 1 to 59 minutes: it beeps when the time has run out. This function
is always available and is indicated by the clock symbol (24) which is located between the − and
+ keys (the symbol may be less bright if another cooking zone timer has a remaining time that is
less than that set on the independent timer).
A zone timer from 1 to 59 minutes for each cooking zone: it beeps when the time has run out.
The cooking zones can be programmed independently (the symbol may be less bright if another
cooking zone timer has a remaining time that is less than that set on the independent timer).
There's a zone timer indicator in each zone display. The timer with the least time is highlighted
and the related clock icon is brighter (13-24). The other timer settings are still active and
running, but the clock icon (13-24) will be less bright. Another icon with the word "min" (23)
appears when you set times longer than 10 minutes. For example 0.11 indicates 0 hours and 11
minutes. The separator dot (21) flashes when the timer is running, while the dot is static while
the timer is selected and thus modifiable.
INDEPENDENT TIMER
INDEPENDENT TIMER
If the touch display is on, the independent timer can be used by simultaneously touching the +
and − keys. If all the cooking zones are in position "0", this is the only timer available. The clock
icon (24) will turn on and the display will show "0.00". If you do not select any key, the timer
deactivates within 5 seconds.
The time setting (0-1hour 59min) can be changed in increments of one minute with the + key
from 0 to 99.
Holding down the
or − key dynamically increases the rate of change up to a maximum value,
+ +
without beeps.
If the + (or −) key is released, the rate of increase (decrease) starts again from the initial value.
The timer can be set by either continuously touching the + or − keys or by touching successively
(with beeps).
After the timer is set, it begins to count down. The completion of the time is signalled by a
beep or by the flashing of the timer display, which will show "00".
TURNING OFF/CHANGING THE TIMER
TURNING OFF/CHANGING THE TIMER
The timer can be changed or turned off at any time by turning on the touch display again, if no
cooking zone is on, and touching the
point, set it to "0" by touching the
time setting.
The independent timer remains active even when the On/Off key is touched.
(CONT.)
and
keys simultaneously to select the timer. At this
+ +
− −
key, to turn it off, or by touching the
− −
key to increase the
+ +
©2020 Hestan Commercial Corporation
EN
17

Publicité

Chapitres

Table des Matières
loading

Ce manuel est également adapté pour:

Kic36-msKic36-bkKic30-ms

Table des Matières