Kichler 52 Range LED Manuel D'instruction page 9

HANGING THE FAN
Step 6. Pass the clevis pin through the downrod and coupling found on the Step 6.
motor assembly, and secure with the hair pin. Tighten set screws found on
the coupling. (Fig. 11 )
Step 7. Now lift the motor body into position and place the hanger ball into Step 7.
the mounting bracket. Rotate until the "Check Tab" has dropped into the
"Registration Slot" and seats firmly. (Fig. 12) The entire motor body should
not rotate if this is done correctly.
WARNING: Failure to properly seat the "Check Tab" can damage the ceiling WARNING:
fan during operation.
Hairpin
Clevis Pin
Set Screw
Coupling
Fig. 11
Registration Slot
Check Tab
OK
NO
Fig. 12
52" Range LED | 9