Kichler 52 Range LED Manuel D'instruction page 8

HANGING THE FAN
Step 3. Remove the hairpin and clevis pin from the downrod assembly, retain Step 3.
for later use.(Fig.8)
Step 4. Loosen the two set screws on the motor coupling.(Fig. 9) Step 4.
Step 5. Place the coupling cover, canopy hole cover and canopy over the Step 5.
coupling found on the top of the motor assembly. Carefully feed fan wires
from the motor assembly through the downrod, then insert the downrod into
the coupling.(Fig.10)
8 | KICHLER.COM
Hair pin
Fig. 8
Set Screw
Fig. 9
Coupling
Fig. 10
Clevis Pin
Downrod
Canopy
Canopy Hole Cover
Coupling Cover