Drill Electrical Opening; Attach Vent Damper Or Transition - Whirlpool UXT5230BF Instructions D'installation Et Guide D'utilisation Et D'entretien

7. Drill Electrical Opening

Using a 1 / " (3 cm) drill bit, drill the hole in the dot
1
4
marked previously at the electrical strain relief.
OPTIONAL: Using a / " (3 mm) drill bit, drill pilot holes
1
8
for the dots marked previously at each mounting tab
at an approximate 45° angle in an upward direction.
8. Prepare Range Hood Vents
and Mounting Tabs
C
B
A
Install Strain Relief
■
Install a UL listed/CSA approved
Mounting Tabs
■
Start a #8-18 x / " (4.2 x 16 mm) truss-head screw into
5
8
the mounting tab (F) on each side of the range hood
as shown in the inset. Insert the screws approximately
2 turns into the mounting tab holes.
Non-vented (Recirculating) Installations
■
Remove the (2) T10 Torx
rectangular vent cover (E). Go to Step 12.
3 / " x 10" (8.3 x 25.4 cm) Rectangular Vent Installations
1
■
4
For top vent installations, remove the top rectangular
vent knockout (C).
For wall vent installations, remove the rear rectangular
vent knockout (B).
7" (17.8 cm) Round Vent Installations
■
Remove both top knockouts (C and D).
F
x2
E
D
/ " (13 mm) strain relief (A).
1
2
screws and remove the top, front
®
OR

9. Attach Vent Damper or Transition

3 / " x 10" (8.3 x 25.4 cm) Rectangular Vent Damper
1
4
Using (2) short Phillips head screws, install the 3
(8.3 x 25.4 cm) rectangular damper over the top or rear
vent knockout removed in Step 8.
NOTE: If the wall cap used has a damper and it interferes with
the rectangular damper, remove the rectangular damper flap.
7" (17.8 cm) Round Vent Mounting Plate
B
Using (2) short Phillips head screws, install the 7" (17.8 cm)
■
round vent mounting plate over the vent knockouts removed
in Step 8. Position the wide flange (C) to the front.
NOTE: An optional 7" (17.8 cm) round damper (A), Part
Number W10355451, and a 7" (17.8 cm) round vent
mounting plate (B), Part Number W10388168, are available
as accessories. For information on ordering, see the
"Assistance or Service" section.
If installing the optional round damper, position it over the
■
round vent mounting plate.
/ " x 10"
1
4
A
C
9