Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
5. Mark Hole Locations
Lift the range hood into place and insert the mounting bracket
tabs through the slots in the back of the range hood.
C
D
Hold the range hood firmly in place with one hand and
bend each mounting tab (A) upward approximately 90°.
OPTIONAL: Mark the hole in each mounting tab.
Mark the hole at the power supply knockout (B).
For a non-vented (recirculating) installation: Go to Step 7.
For a top vented installation: Mark the 4 vent hole
locations (C) on the top of the range hood.
For a rear vented installation: Mark the 4 vent hole
locations (D) on the rear of the range hood.
Remove the range hood and set it aside.
8
A
90¡
C B
D
6. Mark and Cut Vent Opening
3
/
" x 10" (8.3 x 25.4 cm) Rectangular Vent System
1
4
Using a
/
" (13 mm) drill bit, drill a hole in each of the dots
1
■
2
marked previously on either the wall or upper cabinet. Using
the outside edges of the holes, mark the vent opening.
Using a jigsaw or keyhole saw, cut the vent opening.
■
7" (17.8 cm) Round Vent System
Using the 7" (17.8 cm) round vent mounting plate, draw the
■
vent opening outline on the underside of the cabinet:
Place the vent mounting plate on the bottom of the
-
cabinet. Position the edge of the plate with the widest
distance (A) between the hole and edge of the mounting
plate against the wall. Position the side edges of the
mounting plate between the dots marked previously.
IMPORTANT: The widest edge (A) of the vent mounting plate
must be positioned against the wall.
Trace the 7" (17.8 cm) vent opening (solid line) on the
-
cabinet bottom.
Using a jigsaw or keyhole saw, cut the vent opening
■
1" (2.5 cm) larger than the 7" (17.8 cm) hole traced
(dashed line).
1"
(2.5 cm)
A
Publicité
Table des Matières
