Technical Data; Limited Warranty - GreenWorks 20232 Manuel D'opérateur

Problem Possible cause
The motor runs The chain is too
but the chain does tight.
not rotate.
The guide bar and
the chain are dam-
aged.
The motor is dam-
aged.
The motor runs
The chain is blunt.
and the chain ro-
tates, but the chain
does not cut.
The chain is in the
incorrect direction.
The chain is tight
or loose.
The machine does
not start.
The lock-out but-
ton and the trigger
are not pushed at
the same time.
The motor runs,
The machine is in
but the chain does
the protection
not cut correctly,
mode to protect
or the motor stops
the PCB.
after around 3 sec-
onds.
The chain is not
lubricated.
English
13
Solution
Adjust the chain
Motor
tension.
Replace the guide
No load speed
bar and the chain
if it is necessary.
Guide bar length
1. Pull the mains
Chain pitch
plug out of the
Chain gauge
socket.
Drive links
2. Remove the
guide bar cov-
Chain oil capacity
er.
Weight (without battery
3. Remove the
pack)
bar and saw
chain.
Chain
4. Clean the ma-
Guide bar
chine.
5. Re-start the
machine.
14
If the sprocket ro-
tates, it means the
motor works prop-
erly. If not, call
service center.
Sharpen or replace
the saw chain.
Turn the chain
loop to the other
Greenworks hereby warranties this product, to the original
direction.
purchaser with proof of purchase, for a period of three (3)
years against defects in materials, parts or workmanship.
Adjust the chain
Greenworks, at its own discretion will repair or replace any
tension.
and all parts found to be defective, through normal use, free
1. Push the lock-
of charge to the customer. This warranty is valid only for
out button and
units which have been used for personal use that have not
hold it.
been hired or rented for industrial/commercial use, and that
2. Push the trig-
have been maintained in accordance with the instructions in
ger to start the
the owners' manual supplied with the product from new.
machine.
Release the trigger
ITEMS NOT COVERED BY WARRANTY:
and start the ma-
1. Any part that has become inoperative due to misuse,
chine again. Do
not force the ma-
chine to cut.
2. The unit, if it has not been operated and/or maintained in
Lubricate the
chain to decrease
3. Normal wear, except as noted below;
the friction. Do
4. Routine maintenance items such as lubricants, blade
not let the guide
bar and the chain
5. Normal deterioration of the exterior finish due to use or
operate without
sufficient lubri-
cant.
13

TECHNICAL DATA

120 V AC, 60 Hz, 12.0
Amp
8500±10% RPM
16" (400 mm)
3/8" LP (9.5 mm)
0.05" (1.27 mm)
56
150 ml
8.8 lbs (4 kg)
91PJ056X/CL15056X
160SDEA041/
M1501656-1041TL

LIMITED WARRANTY

3
LIMITED WARRANTY
GARANTIE LIMITÉE
GARANTÍA
LIMITADA
commercial use, abuse, neglect, accident, improper
maintenance, or alteration; or
accordance with the owner's manual; or
sharpening;
exposure.
YEAR
ANS
AÑOS
EN