Sherco CityCorp 4T 125cc Manuel Du Propriétaire page 44

2.4 Automatic trip function (TD)
This function describes the function/display of the unit's automatic
trip function. This function is always shown using the 2-5 digits and
is accompanied by the letters TD, as shown in Fig.5; the figure shown
represents the distance run by the bike expressed in kilometres or
miles (depending on the unit of measurement selected), with a reso-
lution of 0.1 (kilometres or miles); this counter is automatic: it is
activated by the first impulse from the speed sensor. The figure is
not saved permanently. It is possible to zero the counter associated
with this parameter by pressing the button (below the TD function)
for about 3 seconds until the value 000.0 appears. The zeroing of the
TD can be effected both while stationary and whilst moving, and also
zeroes the LAP function. If the figure exceeds 999.9, the system will
automatically zero the TD and LAP, and will then restart the trip.
fig.5 TD function
2.5 Automatic trip function (CountDown)
This function describes the function/display of the unit's countdown
trip function. This function is always shown using the 2-5 digits and
is accompanied by the flashing letters TD (see Fig.6); the counter is
always active and counts down with a resolution of 0.1 (kilometres
or miles depending on the unit of measurement selected). It is pos-
sible to modify the value associated with this parameter by pressing
the button (below the TD function and whilst stationary) for about 3
seconds until only the segments relative to the countdown function
and the letters TD (still flashing) are active, while all the other seg-
ments are switched off, as shown in Fig.7.
44