Initial Operations - Sherco CityCorp 4T 125cc Manuel Du Propriétaire

1
5
4
3
2
N
1
The break in period if 500 km. During this period it is mandatory that you
follow the procedures described below.
If these procedures are not followed the life of your motorcycle may be
drastically reduced.
- Do not accelerate or race the engine immediately after starting. Let the
engine idle for a few minutes in order for it to warm up.
- Do not run at full load during the break in period.
- In order to validate the manufacturers warranty, you must return your
Sherco motorcycle to your authorized Sherco dealer at the end of the 500
km break in period.
38
1. The gear shift lever which is loca-
ted on the left side of the engine
is used to select the 5 gears in the
transmission
OFF: When the lever is in this posi-
tion, fuel will not flow. Always return
the lever to this position when the
engine is not running.
ON: With the lever in this position,
fuel flows to the carburetor. Normal
riding is done with the lever in this
position.
RES: This is the reserve position.
If you run out of fuel while riding,
move the lever to this position.
IN IT IA L OP ERATI O N
G e a r s h i f t l e v e r
3 positions fuel petcock