Sherco CityCorp 4T 125cc Manuel Du Propriétaire page 54

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

2
1
1
2
3
4
2
1
54
Front brake adjustment
1. Loosen the lock nut (1).
2. Turn the adjuster (2) until you obtain a 10
mm (approx.) clearan ce between the brake
lever and the handlebar grip.
3. Tighten the lock nut (1).
Rear brake adjustment
The top of the brake pedal should be
approx. 15 mm belos the top of the foot peg.
1. Loosen the lock nut (1).
2. Turn the adjuster (2) until you obtain
the 15 mm dimension. Apply pressure to
the brake pedal when you have the correct
dimension.
3. Tighten the lock nut (1).
The rear brake pedal should have a clearan-
ce of approx. 3 mm with the stop screw.
1. Loosen the lock nut (3).
2. Turn the adjuster (4) until you obtain the
3 mm dimension.
3. Tighten the lock nut (3).
Clutch lever adjustment
There are two places to adjust the clutc cable:
one is on the lever and the other is on the
cable near the engine. This illustration shows
the clutch lever adjustment.
1. Loosen the lock nut (1).
2. Adjust the adjuster (2) until you obtain a free
play of approx. 10 to 15 mm.
3. Tighten the lock nut (1).

Publicité

Table des Matières
loading

Table des Matières