Sherco CityCorp 4T 125cc Manuel Du Propriétaire page 49

2.9 Button function
The function of the button varies depending on the function displa-
yed, as shown in the table below.
Fonction
TIME
LAP
TOD
TD
2.10 Initial installation of instrument
The default value of the wheel circumference is 2,091mm, and the
unit of measurement is k.p.h. for the speed and kilometres for dis-
tance; again by default, the system is set to receive 1 impulse for
each complete turn of the wheel. To modify any of these parame-
ters, it is necessary to proceed as per the instructions above. During
the initial installation of the instrument, the display will Visualize
the version and date of the software installed for about 2 seconds.
Immediately after the display's Check, and the visualisation of the
pre-set wheel circumference and number of impulses for each turn
of the wheel, the system activates the standard operating mode.
If T≥3" and Speed = 0, the time-setting function is activated
If T<3" or Speed>0, the functions may be scrolled through
If T≥3" LAP and TD are reset
If T<3" the functions may be scrolled through
If T≥3" and Speed>0, the circumference, unit of measure-
ment and number of impulses per turn of the wheel func-
tion is activated
If T<3" or Speed>0, the functions may be scrolled through
If T≥3" LAP and TD are reset
If T<3" the functions may be scrolled through
If T≥3" and Speed>0, the countdown setting function is
activated
If T<3" or Speed>0, the functions may be scrolled through
MODE
49