Setting "Presence Range" Parameter - Waldmann POWER III Mode D'utilisation

Parameter setting | Explained step by step
6.14 Setting "Presence range"
parameter
For luminaires equipped with a HFMD sen-
sor: This parameter allows you to set the
detection range of the sensors.
You can set the presence range in six steps
of between 10 % and 100 %.
Factory setting: As-delivered, the pres-
ence range is 40%.
X Press both keys simultaneously and
keep them depressed for ten seconds.
The first LED on the light bar is lit.
X Press both keys again simultaneously
and keep them depressed for five sec-
onds.
The first and second LEDs on the light
bar are lit.
X Press both keys again simultaneously
and keep them depressed for five sec-
onds.
The first, second and third LEDs on the
light bar are lit.
X Press both keys again simultaneously
and keep them depressed for five sec-
onds.
The first, second, third and fourth LEDs
on the light bar are lit.
X Release both keys.
One or more LEDs are lit. The remain-
ing LEDs are flashing.
X Set the desired presence range.
- If you want to increase the presence
range, press the upper key.
- If you want to decrease the pres-
ence range, press the lower key.
The LEDS on the light bar that are lit
show the set presence range:
Fig. 14: Presence range = 10 %
Fig. 15: Presence range = 20 %.
Fig. 16: Presence range = 40 %.
Fig. 17: Presence range = 60 %.
Fig. 18: Presence range = 80 %.
Fig. 19: Presence range = 100 %.
X Wait for ten seconds.
The setting is saved.
ENG
31