Setting "Write Protection" Parameter; Setting "Light Control" Parameter - Waldmann POWER III Mode D'utilisation

Parameter setting | Explained step by step
6.3 Setting "Write protection"
parameter
This parameter allows you to enable and
disable the write protection of the control.
If the parameter is ON, the previously set
brightness of the luminaire will be locked.
Accordingly, the setting is protected from
being changed by users.
If the parameter is OFF , users can set the
brightness individually.
Factory setting: As-delivered, the param-
eter is OFF.
X Press both keys simultaneously and
keep them depressed for ten seconds.
The first LED on the light bar is lit.
X Press the lower key three times.
The fourth LED on the light bar is lit or
is flashing.
X To change the parameter setting, press
the upper key once.
If the LED on the light bar is lit, the
parameter is ON.
If the LED on the light bar is flashing,
the parameter is OFF .
X Wait for ten seconds.
The setting is saved.
6.4 Setting "Light control"
parameter
This parameter allows you to enable and
disable the light control of the luminaire.
If the parameter is ON and the brightness in
the detection range of the daylight sensor
changes, the control will adjust the bright-
ness of the luminaire such that the work
area is illuminated uniformly.
If the parameter is OFF , the control will
not control the brightness of the luminaire.
Factory setting: As-delivered, the param-
eter is ON.
X Press both keys simultaneously and
keep them depressed for ten seconds.
The first LED on the light bar is lit.
X Press the lower key four times.
The fifth LED on the light bar is lit or
is flashing.
X To change the parameter setting, press
the upper key once.
If the LED on the light bar is lit, the
parameter is ON.
If the LED on the light bar is flashing,
the parameter is OFF .
X Wait for ten seconds.
The setting is saved.
ENG
25