Setting "Presence Control" Parameter; Setting "Demo Mode" Parameter - Waldmann POWER III Mode D'utilisation

ENG
6.5 Setting "Presence control"
parameter
This parameter allows you to enable and
disable the presence control of the lumi-
naire.
If the parameter is ON, the sensors detect
presence in their detection range and the
brightness of daylight is not sufficient, the
luminaire will remain switched on - irrespec-
tive of whether the luminaire was switched
on by hand or via the automatic switch-on.
If the sensors detect no presence in their
detection range within the set follow-up
time, the luminaire will be switched off
automatically.
If the parameter is OFF , the luminaire will
not react to presence.
Factory setting: As-delivered, the param-
eter is ON.
X Press both keys simultaneously and
keep them depressed for ten seconds.
The first LED on the light bar is lit.
X Press the lower key five times.
The sixth LED on the light bar is lit or
is flashing.
X To change the parameter setting, press
the upper key once.
If the LED on the light bar is lit, the
parameter is ON.
If the LED on the light bar is flashing,
the parameter is OFF .
X Wait for ten seconds.
The setting is saved.
26
Parameter setting | Explained step by step
6.6 Setting "Demo mode"
parameter
This parameter allows you to enable the
demo mode of the control, in order to test
or demonstrate the functions of the lumi-
naire.
If the parameter is ON, all control times are
in the seconds range, allowing you to imme-
diately see, for example, the light control
as a function of the surrounding light or the
presence control. If no key is pressed, the
demo mode will be automatically enabled
again after 10 minutes. If a key is pressed
within these 10 minutes, the demo mode
will be restarted and run for another 10
minutes.
If the parameter is OFF , the set control
times will apply.
Factory setting: As-delivered, the param-
eter is OFF.
X Press both keys simultaneously and
keep them depressed for ten seconds.
The first LED on the light bar is lit.
X Press the lower key six times.
The fifth and sixth LEDs on the light bar
are lit or are flashing.
X To change the parameter setting, press
the upper key once.
If the LEDs on the light bar are lit, the
parameter is ON.
If the LEDs on the light bar are flashing,
the parameter is OFF .
X Wait for ten seconds.
The setting is saved.