Overview; Operating Element; Displays - Waldmann POWER III Mode D'utilisation

ENG
3.

Overview

3.1

Operating element

Fig. 2: Multifunction pushbutton.
3.2

Displays

Light bar in the multifunction push-
button
Fig. 3: Light bar in the multifunction pushbutton.
The six LEDs on the light bar can display
the following parameterisation states in the
parameterisation mode:
Level that is currently active
ƒ
Parameter that is currently active
ƒ
Setting of the active parameter:
ƒ
- LED is lit: Parameter is ON
- LED is flashing: Parameter is OFF
- Set level of the "Follow-up time"
and "Presence range" parameters
20
LEDs in the sensors
Fig. 4: Sensors | LED I.
Fig. 5: Sensors | LED II.
The LEDs in the sensors at the underside
of the luminaire head can display the follow-
ing states, when the luminaire is lit and the
"Sensor LED" parameter is on.
LED Meaning
LED Indirect light of the
I
lit in red luminaire is on.
LED Direct light of the
II
lit in red luminaire is on.
LED Indirect light and direct light
I
and LED of the luminaire are on.
II
are lit in
red
LED The luminaire is being
I
and LED dimmed.
II
are flashing
in
red
LED briefly The sensors of the lumi-
I
flashes in naire detect a presence.
green
LED The sensors detect a fault.
I
and LED In most cases, an oscillat-
II
are lit in ing motion interferes (for
blue example a fan or the like).
The message disappears
as soon as the source of
interference is removed.
Tab. 1: Meaning of the sensor LEDs.
Overview