Parameter Setting | Explained Step By Step; Setting "External Switching" Parameter; Setting "Eco Mode" Parameter - Waldmann POWER III Mode D'utilisation

ENG
6. Parameter setting |
Explained step by step
6.1 Setting "External switching"
parameter
This parameter allow you to set whether
the luminaire can be switched on and off
externally, for example via a wired socket.
If the parameter is ON, the luminaire will
switch to brightness saved last when the
socket is supplied with power.
If the parameter is OFF , the luminaire will
remain off and is ready for operation.
Factory setting: As-delivered, the param-
eter is OFF.
X Press both keys simultaneously and
keep them depressed for ten seconds.
The first LED on the light bar is lit.
X Press the lower key once.
The second LED on the light bar is lit
or is flashing.
X To change the parameter setting, press
the upper key once.
If the LED on the light bar is lit, the
parameter is ON.
If the LED on the light bar is flashing,
the parameter is OFF .
X Wait for ten seconds.
The setting is saved.
24

Parameter setting | Explained step by step

6.2 Setting "ECO mode"
parameter
For luminaires equipped with LUM CON-
NECT VTL: This parameter allows you to
enable and disable the ECO mode.
If the parameter is ON, the indirect light of
the luminaire will be reduced as soon as
the direct light reaches a low level.
If the parameter is OFF , the indirect light
will not be reduced.
Factory setting: As-delivered, the param-
eter is OFF.
X Press both keys simultaneously and
keep them depressed for ten seconds.
The first LED on the light bar is lit.
X Press the lower key twice.
The third LED on the light bar is lit or
is flashing.
X To change the parameter setting, press
the upper key once.
If the LED on the light bar is lit, the
parameter is ON.
If the LED on the light bar is flashing,
the parameter is OFF .
X Wait for ten seconds.
The setting is saved.