Parameter - Waldmann POWER III Mode D'utilisation

Overview
3.3

Parameter

NOTE: The values printed in bold show the factory setting.
Parameter
Level 1
1.1 Not used
1.2 External switching
1.3 For LUM CONNECT VTL: ECO
mode
1.4 Write protection
1.5 Light control
1.6 Presence control
1.7 Demo mode
Level 2
2.1 High sensitivity (HFMD only)
2.2 Automatic switch-on
2.3 Dual sensors
2.4 Sensor LED
2.5 For LUM CONNECT VTL: VTL
2.6 Parameterisation protection
2.7 Not used
Level 3
3.1 Follow-up time = 5 minutes
3.2 Follow-up time = 10 minutes
3.3 Follow-up time = 15 minutes
3.4 Follow-up time = 20 minutes
3.5 Follow-up time = 25 minutes
3.6 Follow-up time = 30 minutes
Level 4 (HFMD only)
4.1 Presence range = 10 %
4.2 Presence range = 20 %
4.3 Presence range = 40 %
4.4 Presence range = 60 %
4.5 Presence range = 80 %
4.6 Presence range = 100 %
Tab. 2: Parameters at each setting level.
LED on the light bar
ENG
Factory setting
ON/OFF
ON/OFF
ON/OFF
ON/OFF
ON/OFF
ON/OFF
ON/OFF
ON/OFF
ON/OFF
ON/OFF
ON/OFF
ON/OFF
ON/OFF
ON/OFF
ON/OFF
ON/OFF
ON/OFF
ON/OFF
ON/OFF
ON/OFF
ON/OFF
ON/OFF
ON/OFF
ON/OFF
ON/OFF
ON/OFF
21