Parameter setting | Explained step by step
6.7
Setting "High sensitivity"
parameter
This parameter allows you to set the sen-
sitivity of the presence control.
If the parameter is ON, the sensitivity of
the presence control is high.
If the parameter is OFF , the sensitivity of
the presence control is reduced.
Factory setting: As-delivered, the param-
eter is ON.
X Press both keys simultaneously and
keep them depressed for ten seconds.
The first LED on the light bar is lit.
X Press both keys again simultaneously
and keep them depressed for five sec-
onds.
The first and second LEDs on the light
bar are lit.
X Release both keys.
The first LED on the light bar is lit or
is flashing.
X To change the parameter setting, press
the upper key once.
If the LED on the light bar is lit, the
parameter is ON.
If the LED on the light bar is flashing,
the parameter is OFF .
X Wait for ten seconds.
The setting is saved.
6.8
Setting "Automatic switch-on"
parameter
This parameter allows you to enable and
disable the automatic switch-on of the
luminaire.
If the parameter is ON, the sensors detect
presence in their detection range and the
intensity of the daylight is not sufficient, the
luminaire will be automatically switched on.
If the parameter is OFF , the luminaire will
not be automatically switched on.
Factory setting: As-delivered, the param-
eter is ON.
X Press both keys simultaneously and
keep them depressed for ten seconds.
The first LED on the light bar is lit.
X Press both keys again simultaneously
and keep them depressed for five sec-
onds.
The first and second LEDs on the light
bar are lit.
X Press the lower switch once.
The second LED on the light bar is lit
or is flashing.
X To change the parameter setting, press
the upper key once.
If the LED on the light bar is lit, the
parameter is ON.
If the LED on the light bar is flashing,
the parameter is OFF .
X Wait for ten seconds.
The setting is saved.
ENG
27