For Your Safety; Validity Of These Instructions; Factory Setting; Instantly Ready For Operation - Waldmann POWER III Mode D'utilisation

For your safety

1. For your safety
These operating instructions describe how
to set individual parameters - parameterise
- the POWER Control in combination with
a Waldmann luminaire.
These operating instructions do not replace
the instructions for use of the luminaire.
X Read and observe the instructions for
use and the safety instructions and
warnings contained therein.
1.1

Validity of these instructions

These instructions apply to luminaires
equipped with a type III multifunction push-
button.
Fig. 1: Type III multifunction pushbutton.
2.

Factory setting

2.1

Instantly ready for operation

The luminaires are set in factory such that
initially they can be operated without chang-
ing the settings.
If you want to set individual parameters in
the control: Read chapter 4 "Parameteri-
sation of the control | Basic procedure" on
page 22.
2.2

Performing a reset

A reset restores the factory setting of the
control.
NOTE: If you want to restore the factory
setting of the control, all parameters will
be reset to their factory settings. Excep-
tion: With the parameterisation protection
enabled, the parameters will not be reset.
X Disconnect the luminaire from the
power supply.
X Press the upper and lower buttons,
keep them depressed and reconnect
the luminaire to the power supply.
This concludes the restoration of the
factory setting.
ENG
19