Parameterisation Mode; Loading The Parameterisation Mode; Switching Setting Levels; Switching Parameters - Waldmann POWER III Mode D'utilisation

Parameterisation mode

5. Parameterisation mode
To allow you to set the parameters of your
luminaire, you have to load the parameter-
isation mode.
The individual parameters are located at
different setting levels displayed on the
light bar of the multifunction pushbutton
via LEDs.
Each parameter has a specific location at
the setting level. To see an overview of
the setting levels and the parameters con-
tained therein, see chapter 3.3 "Parame-
ter" , page 21.
5.1 Loading the parameterisation
mode
NOTE: If you don't press any key in the
parameterisation mode for ten seconds,
you will exit the parameterisation mode.
Previously changed parameters will be
saved.
X Press both keys simultaneously and
keep them depressed for ten seconds.
The first LED on the light bar is lit or
is flashing.
The control is in the parameterisation
mode.
The control is at the first setting level.
5.2

Switching setting levels

TIP: When the control is in the parameteri-
sation mode, you can also display the cur-
rent level: To do so, briefly press both keys
simultaneously. During that time, the light
bar will show the current level.
X Press both keys simultaneously and
keep them depressed for five seconds.
The first LED on the light bar is lit or
is flashing.
The control is now at the next setting
level.
5.3

Switching parameters

Fig. 6: Multifunction pushbutton | lower key.
X Press the lower key.
The next parameter within the selected
setting level will be displayed on the
light bar.
5.4

Changing parameters

Fig. 7: Multifunction pushbutton | upper key.
X Press the upper key.
If the LED of the parameter is lit, the
parameter is ON.
If the LED of the parameter is flashing,
the parameter is OFF .
5.5 Saving settings and exiting
the parameterisation mode
X Wait for ten seconds.
The control is no longer in the param-
eterisation mode. Previously changed
parameters will be saved.
ENG
23