Publicité
Les langues disponibles
Les langues disponibles
Programming – manual
Programming door calls
Application
Call from the door station to an
indoor device.
1 Activate the programming mode
on the SNG 850-... Briefly press the
programming mode button, LED 1
flashes every 2 seconds.
3b Bus video panel
Tap Settings; > Installation; > Start
Programming; > Start. The bus video
panel establishes the speech con-
nection to the door station. The bus
video panel is now in the program-
ming mode.
10
The call tone volume can be set on
the indoor device see operating
instructions.
2 On the door station, press and
hold the programming button
behind the front panel for 4 sec-
onds. A sustained acknowledge-
ment tone will sound, which briefly
repeats every 5 seconds while pro-
gramming mode is active.
4 On the door station, press and
hold the desired call button for
4 seconds until a sustained tone can
be heard from the door loudspeaker.
The call button is now assigned to
the bus indoor device.
3a Siedle Basic
Hold down the speech button for
4 seconds. A protracted acknowl-
edgement tone sounds as confirma-
tion and the muting LED begins to
flash. The bus indoor device estab-
lishes the speech connection to the
door station. The bus indoor device
is now in the programming mode.
4 Sek.
5 The call button is now firmly
assigned to the bus indoor devices.
Program additional users using the
same procedure or quit the pro-
gramming mode.
Publicité
