Assembly; Checking And Replacement Of The Step Polyamide Bearings; Disassembly - Astralpool WATERLIFT Manuel D'instructions

Maintenance
Fig. 40: Lift dismantling.
3. Dismantle the motor cover removing the 6 screws that fasten it.
Fig. 41: Assembly underneath the motor cover and polyamide bearing.
4. Remove the drum cover using a 13 mm open-ended wrench.
5. The chain's polyamide bearing is freed after removing the drum cover.
6. Replace the polyamide bearing.

9.6.2 Assembly

To reassemble the unit:
Carry out the points explained in section 9.6.1 in reverse order.

9.7 Checking and replacement of the step polyamide bearings

9.7.1 Disassembly

The Waterlift moving step vertical support on the handrail is carried out thanks to bearings with inner self-
lubricating bushing on the inside.
1. Remove the 3 screws on the front part of the moving step cover.
Instruction Manual Waterlift rev.0.7 -06/09 33/196