Unpacking; Structure Fastening - Astralpool WATERLIFT Manuel D'instructions

Installation
CAUTION
In swimming pools where this wall does not exist, or is not parallel to the guides and to
prevent the unit from being damaged in any way, introduce a building work solution (for
example: built wall, stainless steel box or plastic plug fastened to the pool wall, etc.) to
guarantee this support and the perpendicular position to the Waterlift structure fastened to
the paving.

6.3.3 Unpacking

After choosing and fitting out the final position for the device:
1. Remove the cardboard packaging that has protected the unit during transport.
2. Cut the fastening clamps to release the Waterlift from the pallet and the bottom cover of the packaging.
3. Move the Waterlift to its final position with two or three operators.

6.3.4 Structure fastening

After unpacking the device, the structure can be started to be fastened. To do so:
1. Align the lift to the wall. Check that the wall is perpendicular to the ground on the installation point and
that the device is positioned in the same way on all the support points, as well as being totally flat.
With the Waterlift unloaded, check that the distance between the bottom support of the guide
handrails of the moving step and the wall is 0 to 5 mm, and the support should not be pressed
against the wall at any time.
2. On the final position mark the position of the two perforations ( 10x60 mm), using the holes on the lift
structure as a template.
NOTE
The Waterlift fastenings to the ground should be as near to the end of the structure as possible.
14/196
OK
Fig. 6: Correct Waterlift fastening.
Fig. 7: Fastening points to the paving.
Max.5mm
Instructions Manual Waterlift rev.0.7 -06/09