Calibration Of The Bottom Stop Position - Astralpool WATERLIFT Manuel D'instructions

7.2 Calibration of the bottom stop position

To set this bottom step position to a value other than the factory default setting, proceed as follows:
1. Open the control box cover.
2. Press the up and down buttons of the lift's moving step, inside the control electric box (B and C), to
the required position.
DANGER OF ELECTROCUTION
Calibrate without anybody in the pool, with totally dry hands and opening the control box for just
the time necessary to carry out the operation.
CAUTION
The unit may be damaged when calibrating the up and down buttons. If the maximum lower travel
point is exceeded, the pulling cable is loosened and damaged. Do not exceed the maximum travel
points.
A: Programming button
B: Up button
C: Down button
3. Press the programming button (A) on the control box.
4. Close the control box cover by screwing the six screws.
Instruction Manual Waterlift rev.0.7 -06/09
Fig. 16: Inside the control electric box.
Start-up
C
19/196