Astralpool WATERLIFT Manuel D'instructions page 17

3. Use a cutter to remove any surplus burrs.
NOTE
Adapt the hole to the chosen bushing, with an inner diameter sized according to the section of
cable used.
4. Install the bushing and pass the cable covered with corrugated tube through it.
5. Inside the motor cover, pass the cable behind the electric motor, trying to prevent touching it, and
keeping a minimum distance of 10 mm between the cable and pulling mechanism. If necessary,
flange the two-wire cable to ensure this route and the indicated safety distance.
6. Remove the control box cover by unscrewing the six fixing screws with a suitable screwdriver, as the
power supply box inside the control cabinet is supplied closed.
7. Connect the two terminals to the control box, making sure that their polarity coincides with the polarity
of the strip terminals inside the power box, as can be observed in figure 12.
WARNING
The electronic board may be damaged. Always maintain the same polarity between the power
supply box terminals and the control box terminals.
Fig. 12: Connection between power supply box and control box.
Instruction Manual Waterlift rev.0.7 -06/09
Fig. 11: Assembly underneath the motor cover.
30VDC
A
B
Installation
24DC
B
A
17/196