Black & Decker FX400 Mode D'emploi page 6

ENGLISH
Mains plug replacement
If a new mains plug needs to be fitted:
•
Safely dispose of the old plug
•
Connect the brown lead to the live terminal
of the new plug
•
Connect the blue lead to the neutral terminal
•
If the product is class I (earthed), connect
the
green/yellow lead to the earth terminal
Warning! If your product is class II double
insulated (only 2 wires in the cord set), no
connection is to be made to the earth terminal
•
Follow the fitting instructions supplied with
good quality plugs
•
Any replacement fuse must be of the same
rating as the original fuse supplied with the
product.
Warning! The above section on mains plug
replacement is for authorized service centre
personals.
Assembly
1. Wash all detachable parts (see chapter
'Maintenance and cleaning').
2. For the food processor fit the required
accessory blade (U, V, W or X) onto the
blade holder (T). fit the assembled blade
holder into the food processor jug (S)s
3. For the blender fit the jug seal (E) around the
base of the blender blade (G), place the
blade (G) into the blade holder (F) then place
the blade holder onto the blender jug base
(D).
6
4. For the mincer or grinder fit the jug seal (E)
into the required blade holder (N or Q), then
place the blade holder (N or Q) on to the
required jug base (L or O).
5. Secure the blade holder (F, N or Q) by
turning it anti clockwise.
Use
1. Place the appliance on a flat, stable surface.
2. Put the ingredients into the required jug.
3. If using the food processor fit the the lid (Y)
onto the jug (S) by turning it clockwise.
4. If using the blender push the lid (B) and filler
cap (A) onto the jug (C).
5. If using the grinder or mincer seal the jug by
fitting the required blade holder (N or Q) and
with the seal (E) and secure by turning
anti-clockwise.
Note: When using the blender or mincer, the
correct lid must be fitted.
6. Place the jug onto the food processor body
(I).
7. Secure the jug by turning it anti clockwise.
8. Connect it to the electrical supply and select
the required speed using the rotary switch.
The following settings are available:-
P = Pulse Operation
O = Power Off
1 = Low Speed
2 = High Speed
The appliance should be disconnected
from the mains supply before removing
the jug.