Kärcher WD 3 Mode D'emploi page 14

ATTENTION
Always work with an inserted cartridge filter during wet
as well as dry vacuum cleaning!
Before Startup
Illustration
 Mount loose parts delivered with appliance prior to
start-up.
Illustration
 Connect accessories.
Illustration
 Plug in the mains plug.
Illustration
 Turn on the machine.
Dry vacuum cleaning
ATTENTION
Check the filter for damage prior to installation and re-
place as necessary.
Work with a dry cartridge filter only!
Illustration
 Recommendation: To vacuum fine dust, use the
filter bag.
14
Operation
Start up
Information filter bag
– The filling level of the filter bag depends on the dirt
that is sucked in.
– The filter bag needs to be replaced more frequently
while sucking in fine dust, sand, etc.
– Clogged filter bags can burst - therefore make sure
to replace the filter bag in a timely manner!
ATTENTION
Vacuum cold ashes only when using a pre-filter.
Order no. basic design: 2.863-139.0, premium design:
2.863-161.0.
Wet vacuum cleaning
ATTENTION
Do not use a filter bag!
 For vacuuming up moisture or wetness pay atten-
tion to the correct floor nozzle setting and connect
the corresponding accessories.
Note: If the container is full, a float closes the suction
opening, and the appliance works at a higher speed.
Switch off the appliance immediately, and empty the
container.
Cleaning hard to reach locations or, where vacuuming
is not possible, like leaves from a gravel bed.
Illustration
 Connect the suction hose to the blower connection,
this will activate the blower function.
Interrupting operation
 Turn off the appliance.
Illustration
 Hook the floor nozzle into the parking position.
 Turn off the appliance and disconnect the mains
plug.
Empty the container
Illustration
 Remove the appliance head and empty the reser-
voir.
Storing the appliance
Illustration
 Stow away the mains cable and accessory at the
machine. Store the appliance in a dry room.
9
EN
Blowing function
Finish operation