Publicité
Les langues disponibles
Les langues disponibles
Use and installation manual (FR)
GR 40 E - GR 60 E - GR 80 E
USE
Presentation of the device
There are six versions of the gyros available (3 spit heights, 2 types of power: gas and
electricity). Depending on the spit heights, you can roast 15, 25 or 40 kg of meat.
The moving parts of these devices are mounted on ball bearings and the motor is not loaded
endwise.
These devices are for professional purposes and are exclusively for use by qualified staff.
They must be installed according to the current regulations by a qualified installer.
The nameplate is on the back of the device.
Size and capacity
Device
Size
GR 40 E
580 x 660 x 695
GR 60 E
580 x 660 x 870
GR 80 E
580 x 660 x 1045
Technical characteristics
Device
GR 40 E
GR 60 E
GR 80 E
Effective spit
Capacity
height
(en kg)
530
15
660
25
820
40
Power
Number of elements
3600 W
3
5800 W
4
7300 W
5
Operation
The movement of the resistor elements is possible when the two side screws have been
undone so as to adjust the distance between the meat and the heating area.
The front mounted switch is used for starting the spit drive motor.
The devices have a power outlet allowing the use of an electric knife.
There are two or three selectors for adjusting the heating power:
1
Off
½
Half-power
1
Full power
Maintenance
Your device needs to be cleaned regularly with a damp sponge.
Do not clean your device with a jet of water: infiltration could cause it damage.
For better service, we recommend maintenance every six months performed by a qualified
installer.
Installation
Note: The side walls of your device must not be situated near a wall or partition consisting
of flammable material or if so, such materials must be covered with effective insulation.
Allow a distance of 30 cm with respect to the wall.
Electrical connection
Electrical connection must be performed by qualified personnel.
Before making electrical connection, check the permissible voltage and current of your
network.
The GR 40 E gyros are connected to 230 V single phase.
The GR 60 E gyros are connected to 400 V 3 phase + neutral + ground or 230 V single
phase (check the size of the cable conductors is at the least 2.5 mm2)
The GR 80 E gyros are connected to 400 V 3 phase + neutral + ground or 230 V single
phase (check the size of the cable conductors is at the least 4 mm2)
Cable colour correspondence:
Phase
Brown
Neutral
Blue
Ground
Yellow/Green
Publicité
