Adjusting Volume; Checking Battery Status - Motorola DLR120 Mode D'emploi

English
NOTICE:
By default, when the radio is turned on, it
announces the current channel name and battery
status.

Adjusting Volume

• Press the (+) button to increase the volume, or the (-)
button to decrease the volume,
• To mute, press, and hold the (-) button (~2 seconds)
until you hear the voice announcement "Mute".
• To maximize the volume, press and hold the (+) button
(~2 seconds). The volume scrolls up fast to maximum
volume. You hear the volume beeps increment as the
volume increases.
26
NOTICE:
• Radio mute means setting the volume to the
lowest level. (This is to prevent the user from
forgetting to unmute the radio).
• Do not hold the radio too close to the ear when
the volume is high or when adjusting the volume.
There are 16 increments of volume. As the (+)/(-)
buttons are pressed, you hear a beep at the
current volume level. If device is receiving during
volume interaction, received audio is heard at
the new volume instead of beeps.
• When using radio with earpiece, make sure to
adjust the radio volume to the lowest volume
before putting on the earpiece. For more
information, refer to
Use only Motorola Solutions approved
accessories. For more information, refer to
Accessories on page

Checking Battery Status

Short press the Power button to check the battery status.
For more information, refer to
The following table describes the icons:
Acoustic Safety on page 6.
92.
Battery Status on page 19.