Olympus CAMEDIA E-10 Manuel De Base page 11

Attaching the Strap
Slide one end of the strap through a strap
eyelet on the camera. Slide the end of the strap
through the sleeve and frame on the strap, and
then slide the sleeve completely up to the
eyelet. Pull the strap tight around the frame and
make sure that it does not slip. In the same
way, attach the other end of the strap to the
eyelet on the other side of the camera.
Inserting the batteries
You can use 2 lithium battery pack (CR-V3), or
4 AA (R6) Ni-MH, Ni-Cd or Alkaline batteries
with this camera. Make sure the power switch is
at the OFF position. Confirm that the card
access lamp is off. Raise the battery
compartment knob and turn it to the open
position . Remove the battery holder.
If you are inserting lithium batteries, install a set
in each side of the battery holder. If you are
installing AA (R6) batteries, install 2 batteries in
each side of the holder. Make sure that you do
not reverse the polarities of the batteries when
you insert them. Gently press down on the
batteries until they lock in place. Insert the
battery holder into the bottom of the camera.
While pushing down on the battery holder, turn
the battery compartment knob to the close
position .
1
CR-V3
2
3
4
AA (R6) Ni-MH,
Ni-Cd or Alkaline
11