Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Inserting and Selecting Memory
Cards
Memory cards, hereafter referred to simply as
"cards", store the digital images of the pictures
that you take with the camera. The camera can
hold one SmartMedia (SM) and one
CompactFlash (CF) media card.
You can use Olympus or any other brand 3V
(3.3V) SmartMedia memory card (5V cards
cannot be used).
SmartMedia
Make sure that the card access lamp is off.
Press down on the card cover lock and raise it,
and then open the card cover. To insert a
SmartMedia card, hold it with the notched
corner down and insert it into the narrow slot
closest to the rear of the camera. Push the card
completely into the slot. (Insert the SmartMedia
card until you can see above 2 mm of the card
above the edge of the slot.)
To insert the CompactFlash card, hold it with
the arrow facing the rear of the camera and
insert it into the wide slot closest to the front of
the camera. Push the card completely into the
slot. Close the card cover and press it gently
until it locks.
To remove the SmartMedia card, press on it
gently to release it then remove it from its slot.
To remove the CompactFlash card, gently
press the eject button to release it then remove
it from its slot.
When one card is installed in the camera, that
card is automatically selected to store images.
With both cards installed, you can select either
card for storage. When one card becomes full,
you can quickly switch to the other card and
continue shooting. Press and hold down the
SM/CF memory card button, and then slowly
turn the main dial or sub dial until you see
(SmartMedia) or
(CompactFlash) displayed
in the control panel. When you see
SmartMedia card is selected for image storage,
and when you see
, the CompactFlash card
is selected.
12
CompactFlash
, the
Connecting the AC Adapter
Use the optional AC adapter as an alternate
power source for long shooting sessions in
order to conserve battery power. Switch the
camera off and make sure that the card access
lamp is not blinking. Plug the AC adapter power
cord into a power outlet. Remove the DC IN
jack cap on the left side of the camera and
connect the AC adapter to the camera, and
then switch on the camera. Use only the AC
adapter intended for use with this camera. For
details about using the AC adapter in any
country other than where you purchased the
camera and AC adapter, contact an Olympus
Service Center.
AC adapter power cord
plug
AC adapter
Power outlet
OFF
ON
DC IN jack
Publicité
Table des Matières
