Publicité
Les langues disponibles
Les langues disponibles
Installation instructions
Convenient storage drawer
for washing machines
Installation
Note
• Residual water can flow out of the pipes and the detergent drawer if the appliance is tilted.
• The packing material (PS boards) can be used as an installation underlay.
• The appliance shipping restraint must not be mounted for the installation of the convenient storage drawer.
Preparation
Unplug the mains connection plug or switch off at the wall switch.
➤
Remove the water drain pipe at the appliance and the water supply at the cock.
➤
Carry out emergency draining in accordance with the appliance operating instructions.
➤
Installation
1. Pull the appliance out of the niche and remove the
installation plate from the floor; this is no longer
required.
2. Place the convenient storage drawer 1 on the same
spot and remove the drawer 2 by lifting the black rail
springs 4 at the side.
3. Stick the installation template 3 to the floor centrally
between the adjustable feet.
4. Affixing the floor mounting plates
Remove the protective film from the mounting plates.
➤
Lift up the convenient storage drawer and the appliance at the front and move it aside in order to stick
➤
the mounting plates in position.
Clean the adhesive zone with pure benzine or acetone.
➤
Taking the fixing position from the installation template 3, stick the mounting plates to the floor.
➤
Screwing the floor mounting plates
Move the convenient storage drawer aside to drill the mounting plates.
➤
Mark the centre of the holes, using the installation template 3.
➤
Drill ø 6 mm holes and insert plugs. Screw the mounting plate in place. Drilling inaccuracies can be
➤
compensated by means of the eccentric hole in the mounting plate.
5. Pull the convenient storage drawer out of the niche and remove the installation template.
6. Lay the appliance according to drawing on its right-hand side, using packing material as an underlay.
It is important that the appliance is placed on its right-hand side; otherwise troubles can occur in subsequent operation.
7. Loosen the lock nuts using the combi spanner (19 mm)
and unscrew the adjustable feet. Screw mount the feet
connectors 6 by hand as shown in the detail drawing.
8. Screw mount the convenient storage drawer 1 to the
appliance from below, using the hexagon box spanner,
the 4 nuts and the washers 5.
9. Align and position appliance and convenient storage
drawer. Insert the drawer and slide in until the rail springs
reengage.
1
2
3
1
5
11
J265.050-1
23.3.11 ZES
4
3
=
=
6
Publicité
