Product Dimensions And Clearances; Tools And Parts Required; Advance Planning - Monogram Advantium ZSB9231NSS Instructions D'installation

PRODUCT DIMENSIONS AND CLEARANCES

21-1/2"
2-1/4"
1"

TOOLS AND PARTS REQUIRED

)
(NOT SUPPLIED
• #2 Phillips screwdriver
• Hand held drill
• High speed drill bit, 3/32" diameter
• 3/8" slot head screwdriver
• Level
• Saw
• 2x4 or 2x2 lumber for installing runners
or 3/8" plywood for floor (if required)
• Wood screws or other hardware for installing runner or
shelf to support oven (if required)
• Safety glasses or goggles
ELECTRICAL TOOLS AND PARTS
REQUIRED (NOT SUPPLIED)
• Junction box
• Electrical cable (3-conductor or 4-conductor wire as
required by local codes)
• UL-listed conduit connectors
• Wire cutters and wire strippers
FLUSH MOUNT INSTALLATION
This installation method allows for the unit face to be
inline with the cabinet face.
IMPORTANT: HIGH SKILL LEVEL IN CARPENTRY
IS REQUIRED. Non-standard cabinetry may be
required.
Flush installation of the oven will lead to the exposure
of the cabinet face frame edges.
Side cleats may be visible and should be a finished
surface.
31-7000080 Rev.1
Design Information
Door Depth
See table
below
13 1/4"

ADVANCE PLANNING

• These ovens may be installed directly into a 30"
• Cutout dimensions are NOT the same for
IMPORTANT
approved for use above another built-in Advantium
Speedcook oven, a side by side installation or below
a countertop.
• For personal safety, this oven cannot be installed
• The oven must be installed at least 36-3/4" above
• Allow for clearance to adjacent corners, walls,
• Cabinets installed adjacent to wall ovens must have
The oven must be securely installed in a cabinet that
is firmly attached to the house structure. Weight on
the oven door could cause the oven
to tip and result in injury. Never allow anyone to
climb, sit, stand or hang on the oven door.
If installing the drawer accessory, the drawer must
be assembled to the oven prior to installation into
the cabinet. See the Accessory Storage Drawer
Assembly Instructions.
NOTE: Appearance will vary by model.
29-3/4"
Model
ZSB9231NSS
ZSB9232NSS
wide oven cabinet.
installation with or without an accessory storage
drawer. Make sure to use the correct cutout when
preparing the opening.
— This oven is not
in a cabinet arrangement such as an island or
peninsula.
the floor.
drawers, etc.
an adhesion spec of at least 194ºF temperature rating.
20-1/4"
Door Depth
1-3/8"
1-7/16"
3