An Accessory Storage Drawer); Flush Mount; With Accessory Storage Drawer - Monogram Advantium ZSB9231NSS Instructions D'installation

Installation Preparation with Accessory Storage Drawer
Preparation with an Accessory Storage Drawer
As needed, see the Standard Mount Installation Preparation OR Flush Mount Installation Preparation for
configuration details. Note the modified cutout height below.
PREPARE THE OPENING (cont.)
The Advantium Built-In Oven can be installed in combination with other Monogram appliances. Always follow each
product's Installation Instructions to complete the installation.
Single Advantium Built-In Oven Installation:
Order a 30" wide single oven cabinet or cut the opening in a wall to the dimensions shown.
STANDARD MOUNT:
30" 23-1/2"
25-1/4"
Min.
21"
36-3/4"
Min.
Dimension 1/8"
Reveal
K 30"
• For flush installation, make the bottom cleat height 3/4" when installed over a storage drawer.
• Allow the following clearances around the cutout on the front surface of the cabinet : 1−7/8" from the top, 2−3/8"
from the side edges, and 3/4" from the bottom. (Note: these refer to minimum clearances required for installation
and do not reflect actual product dimensions.)
• Oven overlaps will conceal cut edges on all sides of the opening.
• When installed over a single oven or a warming drawer, allow at least 2" between the two openings. This
separation will provide clearance for bottom overlap of the Advantium Built-In Oven and the other appliance
overlaps.
• The support must be level and rigidly mounted, flush with the bottom edge of the cutout.
8
Construct
solid bottom - Min.
3/8" plywood
supported
on all four sides.
Must be able to
support weight
of oven and
contents.
1/4"
Reveal
30-1/4"

FLUSH MOUNT:

23-1/2"
K*
23-5/8"
36-3/4"
Min.
Construct
solid bottom - Min.
3/8" plywood
supported
on all four sides.
Must be able to
support weight
of oven and
contents.
31-7000080 Rev. 1