Rollei Funk Blitzsender Mode D'emploi page 56

3 . After the group settings press [MODE] key to set selected group . Model
56
parameter setting as below:
TTL: Compatible with i-TTL, supports exposure compensation, adjustable range
(-3 .0EV~+3 .0EV), press [left] or [right] key to increase or reduce the value .
M: Flash output range from 1/128~1, press [left] or [right] key to increase or
reduce the value . In total there are 22 grades .
OFF: This group will not flash .
Press the [Up] and [Down] keys to set the value of the focal length of the pa-
cket . If the focal length is set to AU, the receiver flash with the camera lens focal
length information changes . If the focal length value is not AU, the receiver flash
has the focal length of the corresponding packet (the receiving end flash focal
length is set to Auto) .
AU 18 24 28 35 50 70 85 105 135 180
This mode supports three different flash groups to participate in the flash mode
and power exposure .
To use the normal mode, the flash on the receiver can be set to TTL mode .
Then the packet mode and parameter settings on the transmitter will send the
corresponding flash effects . You can also manually flash on the receiver set to a
different flash mode and output power to achieve mixing flash .
Nikon master blend mode does not support remote control on the receiver flash
mode and parameters .
ENGLISH