Canon Mixed Mode - Rollei Funk Blitzsender Mode D'emploi

Canon Mixed Mode

42
Packet mode and parameter settings
1 . Press the [MODE] button to select the Canon
mixed mode (as shown) .
2 . Press the [A] / [B] / [C] buttons, to select the
flash group settings . A small arrow indicates
which group will be set at the moment .
3 . Select the setting group and press the [MODE]
button to set the flash mode . Each mode
parameters are set as follows:
TTL: Compatible with E-TTL II – supports exposure compensation – adjustment
range -3 .0EV ~ + 3 .0EV, press [Left] or [Right] key to increase or decrease the value .
M: Flash output range of 1/128 ~ 1/1, press [Left] or [Right] keys to increase or
decrease the value .
OFF: The group is not involved .
Press the [Up] and [Down] keys to set the value of the focal length of the packet .
If the focal length is set to AU, the receiver flash with the camera lens focal length
information changes . If the focal length value is not AU, the receiver flash has the
focal length of the corresponding packet (the receiving end flash focal length is set
to Auto) .
AU 18
4 . If the grouped flash parameters have been set, press the group button again to
exit . This mode supports three different flash groups to participate in the flash
mode and power exposure . When connecting to a Canon camera, set to TTL
flash mode to achieve E- TTL / II flash .
ENGLISH
24 28 35 50 70 85 105 135 180