Rollei Funk Blitzsender Mode D'emploi page 53

Flash ratio "All" means three slave groups have the same light output . Choose
flash ratio "A: B" which indicates open A / flash group B and group AB can be
set individually power output . Choose flash ratio "A: BC" which indicates that
the three groups are open flash and can be adjusted individually for each set of
power output .
3 . Setting strobe flash frequency
Press the 5 key group [Middle] key and press the[Left] [Right] key to set the
flash frequency (1–199hz) .
4 . Setting multi number of flash
Press <Mid> key until the number marker twinkles . Then press [left] and [right]
key to set the number of flashes .
Group A flash power and number of flash table
Flash power
Number of flash
5 . Setting group B flash output power (A:B or A:B:C)
Press (Mid) key until group B lights on . Press <left> and <right> key to set the
group B output power .
1/128 1/64
1–40 1–20
1/32 1/16
1–12 1–8
1/8 1/4
1–4 1–2
53