Doro SeePlus 314ci Mode D'emploi page 23

English
In Quiet alarm mode ON, the indicator will flash but
no tone will be played, and the emergency message
will only be heard by the receiver of the call.
See Basic setup - Quiet alarm.
Alarm call with the remote
Hold down the button on the cordless remote for
approximately  seconds, until the LED indicator on
the phone flashes. The phone will make the alarm
call as described in Alarm call from the phone.
To terminate the alarm call, press and hold the
button on the remote or any of the keys A/B/C on
the phone. Lifting the receiver will stop the alarm
but not terminate a connected call.
Cordless remote
The button on the cordless remote can be used to
answer an incoming call or to make an alarm call.
The range of the cordless remote varies depending
on the environment in which it is used. Walls,
floors, furniture and other obstacles may limit
contact between the remote and the telephone.
Check that the remote is always in contact with the
telephone by activating the alarm in different places
around the premises.
Five cordless remotes can be registered
simultaneously to the phone. If additional units are If additional units are
registered, the first registered unit will be disabled.
18