Ingersoll Rand UP6 15 Mode D'emploi page 41

CALIBRATION
The dryer is supplied factory set and therefore requires no further
calibration.
ENGINEERING DATA
Compressor
Maximum operating
pressure psig (bar)
Factory set reload
pressure psig (bar)
Model
UP6 15
Pressure Dew Point ( F)
(see note 3. below)
Base–Mounted Dryer
Package Weight (lb)
120 Gallon Tank Dryer
Package Weight (lb)
240 Gallon Tank Dryer
Package Weight (lb)
Electrical Supply
(+/– 10%) (AC)
(see note 2. below)
L.R.A. Current (Amps)
F.L.A. Current (Amps)
Total Installed Power (kW)
Electrical Protection Class
(Std.)
Refrigerant Type
http:/air.ingersollrand.com
UP6 15 - 30
125 150
(8.62) (10.34)
110 135
(7.58) (9.31)
UP6 20 UP6 25
38
1367 1411
1451
1691 1735 1775
1960 2004 2044
115V / 1ph / 60Hz
45.0 45.0 48.8
9.6 9.6 12.3
0.96 0.96 1.19
NEMA 1 (IP20)
134a
Notes:
1. Electrical data refers to dryer only.
2. The dryer requires a separate power supply from the compressor
drive.
3. Rated at:
Working Pressure (psig)
Inlet Air Temperature ( F)
200
(13.79)
Ambient Temperature ( F)
185
Relative Humidity (%)
(12.76)
Notes on the use of the Schrader non–return valve.
ATTENTION
UP6 30
1. This unit is equipped with refrigerant as for quantity and kind clearly
shown in operating manual and with identification label.
2. Any ordinary test and / or refrigerant recharge by means of
1537
connections can take place only after refrigerant evacuation. The
evacuation must be proportional to dimensions and length of the
connections used. The use of the valve can be justified only when the
1861
dryer is not in working order.
2130
3. During the unit guarantee period, the Schrader valve can be used by
authorized staff only, otherwise any damage caused by a wrong
refrigerant recharge will invalidate warranty.
48.8
12.3
1.19
DRYER OPTION
100
100
100
100
UP6 15, UP6 20, UP6 25, UP6 30
39