Garmin EDGE 1040 Manuel De Demarrage Rapide page 4

3 Place the bike mount on the bike
stem.
4 Attach the bike mount securely using
the two bands .
5 Align the tabs on the back of the
device with the bike mount notches
.
6 Press down slightly and turn the
device clockwise until it locks into
place.
4
Installing the Out-Front Mount
1 Select a secure location to mount the
Edge device where it does not
interfere with the safe operation of
your bike.
2 Use the hex key to remove the screw
from the handlebar connector
3 Place the rubber pad around the
handlebar:
• If the handlebar diameter is
25.4 mm, use the thicker pad.
• If the handlebar diameter is
31.8 mm, use the thinner pad.
4 Place the handlebar connector around
the rubber pad.
5 Replace and tighten the screw.
NOTE: Garmin recommends
®
tightening the screw so the mount is
secure, with a maximum torque
.
Quick Start Manual