Faber 3 Step Mode D'emploi page 25

Troubleshooting
Symptom
The fl ame eff ect will
not start.
The fl ame eff ect is too
low.
Unpleasant smell when
unit is used.
The fl ame eff ect has
too much smoke.
Main lamps are not
working and there are
no fl ames or smoke.
Condensation on the
glass
Cause
Mains plug is not plugged in.
Switch A is in the 'ON' ( I ) position, but mode
Switch B has not been pressed. (See Fig. 2)
Low water level.
Low voltage connector not connected properly.
(See Fig. 8)
Flame eff ect thumb wheel is set too low.
(See Fig. 2)
The water in the sump may be too high due to
the drawer being opened and closed a number
of times, water tank removed a number of
times, or the fi re has been moved.
Metal Disc at the base of Sump might be dirty
(See Fig. 13)
Dirty or stale water.
Flame eff ect setting is too high.
There is no water in the tank.
The mist setting is too high
The glass may be cold during product start-up
Corrective Action
Check plug is connected to wall socket correctly.
Press Switch B once for fl ame eff ect. (See Fig. 2)
Check the water tank is full and there is water in
the sump.
Check that the connector is inserted correctly.
(See Fig. 8)
Increase level of fl ame by turning thumb wheel
D clockwise slowly. (See Fig. 2)
If water level in the sump is more than 40mm,
the sump should be removed and emptied in
the sink.
Clean Metal Disc with soft brush supplied. (See
Fig. 13) See 'Maintenance. ' for a step by step
procedure.
Clean the unit as described under maintenance.
Only use tap water in this appliance with a
maximum hardness of 10 dH.
Turn the fl ame eff ect Thumb Wheel 'D' down to
minimum and slowly turn up, about ¼ a turn, at
a time. Give the fl ame generator some time to
adjust before increasing. (See Fig. 2)
Follow instructions under Maintenance, 'Filling
the water tank' .
Check the plug is connected to wall socket
correctly.
Switch 'A' Fig. 2 is in the 'ON' ( I ) position.
Press switch 'B' Fig. 2 until you can hear one
beep only, for fl ame eff ect.
Reduce the mist intensity by turning the thumb
wheel 'D' down
Reduce the mist intensity to low and turn switch
'C' to high speed.
Run the product under this setting until the
glass clears then return to your preferred
setting.
Repeat this procedure should condensation
return
20