Troubleshooting - dB Technologies VIO S318 Caractéristiques Techniques

English

6. TROUBLESHOOTING

The module does not turn on:
1. Check the correct power supply upstream of the system.
2. Check that the power supply or the re-launch connection of the power supply is properly inserted.
The module turns on but does not make any sound:
1. Check that the audio signal input connections or the audio signal re-launches are properly carried out.
2. Check that the Audio Attenuation is set to 0 dB.
3. Check that the audio source (mixer) is properly connected and active.
4. In case of RDNet network connection and control with the DBTECHNOLOGIES NETWORK, verify that the
MUTE function is disabled.
The sound is not completely satisfactory.
1. Re-check the project, the installation and configuration specifications using the DBTECHNOLOGIES
COMPOSER.
2. Verify that the DSP PRESET parameters are actually replicated on the control panel of the module
(especially if the remote control of the module is not used).
3. Check that all the parameters are properly set, in case of RDNet network connection and control with
the DBTECHNOLOGIES NETWORK.
VIO-S318 Cod. 420120244 REV. 1.1
49