Connecting And Re-Launching The Audio Signal And Rdnet - dB Technologies VIO S318 Caractéristiques Techniques

English

CONNECTING AND RE-LAUNCHING THE AUDIO SIGNAL AND RDNET

C
A
The figure above shows a general connection where a subwoofer 1
is under subwoofer 2 as well as the audio and network connections. To this end, use the not supplied
cables with XLR (audio) and etherCON/RJ45 (network) connectors. For further information on the
available types of cables, refer also to the image in next page.
• For audio connection, connect the cable coming from MIXER/LINE to BALANCED AUDIO INPUT
(A) of subwoofer 1. Daisy-chain the signal between the first and the second one. To this end,
connect the BALANCED AUDIO OUTPUT/LIN (B) of subwoofer 1 to BALANCED AUDIO INPUT (C) of
subwoofer 2.
• Repeat this procedure until connecting the whole system.
• For network connection, connect DATA IN connector (A) of subwoofer 1 to remote controller
(RDNet CONTROL 2 or RDNet CONTROL 8). Daisy-chain the signal by connecting DATA OUT (B) of
subwoofer 1 to DATA IN (C) of subwoofer 2.
• Repeat this procedure until connecting the whole system.
WARNING
• Replace any damaged cables to prevent malfunctions and poor sound quality.
VIO-S318
SUBWOOFER 2
SUBWOOFER 1
B
!
C
A B
Cod. 420120244 REV. 1.1
43