Connections; Connecting And Re-Launching The Power Supply - dB Technologies VIO S318 Caractéristiques Techniques

4. CONNECTIONS

CONNECTING AND RE-LAUNCHING THE POWER SUPPLY

The figure above shows a general connection where a subwoofer 1
is under subwoofer 2. To this end, use cables with powerCON TRUE1® connectors (only one power cable
is supplied with the package).
• Connect the power supply of subwoofer 1 to AUTO-RANGE MAINS INPUT (A).
• Daisy-chain the power supply from subwoofer 1 to subwoofer 2, connecting MAINS LINK output (B)
of subwoofer 1 to AUTO-RANGE MAINS INPUT (C) of subwoofer 2 (link cable not supplied).
• Repeat this procedure until connecting the maximum permitted number of the line-array module
(refer to section
WARNING
•
VIO-S318
42
C
A
TECHNICAL SPECIFICATIONS).
!
The cables must be properly sized and the system's design, installation and
testing should be performed by qualified personnel only. AEB industriale declines
any responsibility in case of cables that are non-compliant, uncertified and
incompatible with the proper layout of the system and the regulations in force
for the country of use.
B
English
SUBWOOFER 2
SUBWOOFER 1
Cod. 420120244 REV. 1.1