Victron energy MultiPlus-II 24/3000/70-32 GX Manuel page 127

APPENDIX A: Connection overview
BIJLAGE A: Overzicht aansluitingen
ANNEXE A : Vue d'ensemble des connections
ANHANG A: Übersicht Anschlüsse
APÉNDICE A: Conexiones generales
APPENDIX A: Anslutningsöversikt
APPENDICE A: Panoramica dei collegamenti
EN:
A Load connection. AC-OUT-1 Left to right:N (neutral), PE (earth/ground), L (phase)
B Load connection. AC-OUT-2 Left to right: N (neutral), PE (earth/ground), L (phase)
C AC input. AC-IN Left to right: N (neutral), PE (earth/ground), L (phase)
D Programmable (AUX) relay: left to right NO, NC, COM.
E To start without Assistants: Press and hold this button when starting
F Primary ground connection M6 (PE)
G M8 battery positive connection
H M8 battery minus connection
I Switch: -:On, 0:Off, =:charger only
J Terminals top to bottom:
1. Auxiliary power supply 12V 100mA
2. Programmable open collector output (K1) 70V 100mA
3. External ground relay +
4. External ground relay –
5. Analog/digital (AUX) input 2 +
6. Analog/digital (AUX) input 2 –
7. Analog/digital (AUX) input 1 +
8. Analog/digital (AUX) input 1 –
9. Temperature sense +
10. Temperature sense –
11. Battery voltage sense +
12. Battery voltage sense –
K External current sensor
L 2x RJ45 VE-BUS connector for remote control and/or parallel/three-phase operation
M Connector for remote switch: Short to switch "on".
N Dedicated BMS-Can port (VE.Can not supported)
O USB port
P Reset Button: resets to default settings
Q Ethernet Port
R VE.Direct Port