Drum/Caddy Assembly - RIDGID RV24000 Manuel Du Propriétaire

Drum/Caddy Assembly

If any parts are missing or damaged
contact Customer Service.
Do not assemble until you have all the
parts.
1. Remove Left and Right Caddies from
Drum.
*TIP - Use a 5/8" (16mm) Socket to hold
the Cap Nut in a stable position when
hammering.
2. Install Cap Nut on one side of Shaft
Rod. Tap gently with Rubber Mallet
or Hammer until fully seated. Slide
open end of Shaft through the
Wheel (smooth side of wheel facing
outward).
3. Place Wheel/Shaft Assembly through
Caddy Left and on through the Caddy
Right, as shown.
4. Then place the remaining Wheel onto
the Caddy Assembly (smooth side
of wheel facing outward), and install
second Cap Nut.
5. Invert Drum to install Caddy. Place
the Caddy Assembly onto the Drum,
as shown. Be sure that Wheels
spin freely, and do not contact the
Caddies.
6. Once the Caddies are aligned on
the Drum, gently tap each end of
each Caddy until firmly seated. It
is recommended to tap the center
portion of the Front Caddies, as
shown.
7. Using a Rubber Mallet or Hammer,
gently tap the Wheel Caps onto each
Wheel until the Wheel Caps are firmly
seated onto each Wheel. This is
required on both sides.
SP6729-5 RIDGID ESF 111418.indb 8
NOTE: Smooth side of the
wheel to the outside.
Socket
Shaft
Rod
Caddy
Right
CADDY
ASSEMBLY
1/16" (1.6 mm) 1/16" (16 mm)
Clearance
Clearance
TAP
8
Cap
Nut
Caddy Left
Wheel
Cap
Nut
Caddy
Wheel
TAP
Wheel Cap
Mallet
12/3/18 11:18 PM