Caddy Assembly - RIDGID Smart Pulse RV34100 Manuel D'utilisation

SP6906 RIDGID ESF.qxp_SP6636 12/10/14 9:27 AM Page 8

Caddy Assembly

If any parts are missing or damaged
contact Customer Service.
Do not assemble until you have all the
parts.
1. Insert left caddy and right caddy into
the bottom of drum as shown.
Light taps with a mallet or hammer
may be needed to fully seat both
caddies.
2. Install (4) #10 x 1-3/4" screws into
matching holes on both right and left
side of caddy, securing them to the
bottom of the drum. Tighten screws
until just snug. Do not over tighten as
this may tend to deform the caddies.
3. Installing Cap Nut
a. Place cap nut on end of axle.
b. Tap gently with hammer until fully
seated.
c. Place wheel on the axle with
smooth portion of wheel facing
outward.
Drain
#10 x 1-3/4" Screw (4)
Left
Caddy
Open
End
Cap
Nut
NOTE: Smooth side of the
wheel to the outside.
8
Right
Caddy
Left
Caddy
Left
Caddy
Drain
Right
Caddy
Drain
Right
Caddy
Axle
w/Wheel