Williams MINIJET Serie Manuel Du Propriétaire page 14

Before Use
Tube pressure will fluctuate with temperature.
Inflate tubes in sequence to 250 mB/3.6 psi.
Failure to observe this will compromise the
sea-keeping ability and watertight integrity of
the boat. Inflation valves are fitted with quarter-
turn locks to enable rapid deflation.
CAUTION.
the correct sequence to prevent
over-inflation.
Safety Check!
WARNING.
to the kill cord lanyard before
starting the engine. Before setting off, as a
precautionary measure, always test lanyard for
its functionality by pulling away from its seating
– the engine should always stop.
Power Limit Switch
The power limit switch is located within the
engine bay, on starboard side face. To operate
boat in low power mode, turn key to low
Checking the Oil Level
The engine must be at operating temperature
before an accurate level is indicated on the
dipstick. The oil level should be between MIN
1 Full 2 Add oil 3 Operating Range
14
Tubes must be inflated in
ALWAYS attach yourself
1
•
Set valves to shut and inflate tubes evenly,
starting at rear/right, rear/left, then forward
valves.
• Check bilge for fuel or water contamination.
• Tighten footwell drain plugs.
• Ensure towing valve is set in open position.
• Check engine cover latches are secure.
WARNING.
when bathers are reboarding, as risk
of serious injury exists from reverse deflector.
WARNING.
NEVER investigate engine bay with
engine running or ignition on.
power section of key plate. For full power
mode, turn key into full power section. In both
positions the key can be removed.
and MAX on the dipstick. Reinsert dipstick,
pushing in completely.
Use the correct grade of oil: Williams
recommends XPS-4 stroke synthetic blend
(Summer). Do not overfill.
3
2
NEVER operate the boat