EGO PTX5100 Guide D'utilisation page 19

Vertical Cutting (cutting head at an
angle)
Cutting without standing directly next
to the hedge, e.g. flowerbed between
operator and hedge.
In this cutting position, for your better
control of the hedge trimmer, it is
recommended that connect the hedge
trimmer with the cutting head at the side
cutting position.
Swing the cutting head up and down in an arc as you move along the hedge – use both
sides of the cutting blade
(Fig. 9a).
Vertical Cutting (with straight cutting
head)
Extra long reach without the need for
other aids. Swing the cutting head up
and down in an arc as you move along
the hedge – use both sides of the cutting
blade (Fig. 9b).
HEDGE TRIMMER ATTACHMENT — PTX5100/PTX5100-FC
9a
9b
19