Troubleshooting - EGO PTX5100 Guide D'utilisation

TROUBLESHOOTING

PROBLEM
Hedge trimmer
doesn't work.
Excessive
vibration or
noise.
28
HEDGE TRIMMER ATTACHMENT — PTX5100/PTX5100-FC
CAUSE
◾
No electrical contact between
the trimmer and battery.
◾
The battery pack is depleted.
◾
The battery pack or power
head is too hot.
◾
The blade is jammed.
◾
The hedge trimmer is not well
connected with the power
pole.
◾
Dry or corroded blades.
◾
Blades or blade support is bent.
◾
Bent or damaged teeth.
◾
Loose blade bolts.
SOLUTION
◾
Remove battery, check contacts and
reattach the battery pack.
◾
Charge the battery pack.
◾
Allow the battery pack or power pole to
cool down before restarting the tool.
◾
Remove the battery pack from the tool.
Remove the obstruction carefully and
then reinsert the battery and restart
the tool.
◾
Disconnect the hedge trimmer from the
power pole. Reconnect them following
the section "CONNECTING THE HEDGE
TRIMMER ATTACHMENT TO THE
POWER POLE" in this manual.
◾
Lubricate the blades.
◾
Replace with a new blade or support
following the section" REPLACING THE
BLADE" in this manual or contact EGO
service center for replacement.
◾
Replace with a new blade following
the section" REPLACING THE BLADE"
in this manual or contact EGO service
center for replacement.
◾
Tighten the blade bolts. Using a hex
wrench (not included), turn the bolt
clockwise to tighten.