Brake Handle Assembly - Medline MDS86825DLX3 Guide De L'utilisateur

Brake Handle Assembly

1. Place rollator upright on it's wheels.
2. Insert hand grip into appropriate hole (see Figure A and chart below).
Note: Keep brake cable on outside of rolling walker.
3. I nsert triangular hand screw into hole on outside of rolling walker's frame (see Figure B).
(Important: Insert hand screw into one of the 4 holes provided.
DO NOT put hand screw in open slot at end of hand grip!)
4. Hand tighten screw until secure (see Figure C).
5. Repeat steps 1-4 for other hand grip.
Figure A
Hole 1
Hole 1 29.25" (74.3 cm)
30.00" (76.2 cm)
Hole 2
Hole 3 30.75" (78 cm)
Hole 4 31.50" (80 cm)
Hole 5 32.50" (82.6 cm)
Hole 6 33.25" (84.5 cm)
MDS86825DLX3/4 (GPI171)
Revised (A): 11/26/12
Figure B
To determine the proper height for the hand grip, stand
upright behind the walker with shoulders relaxed, arms hanging
at your side and eyes looking straight ahead. Standing in
current position, the hand grips (A) of the rolling walker should
be adjusted to a height even with the wrists. This will position
the arms at an approximated 20 to 30 degree bend when using
the rolling walker. Secure the hand grip to the closest hole to
the desired height. Insert and tighten the triangular hand screws
until secure.
(Important: Hand Tighten Only!)
Deluxe Rolling Walker Hole Measurements:
Arm Height
Hole 2
30" (76.2 cm)
30.75" (78 cm)
31.75" (81 cm)
32.5" (82.6 cm)
33.25" (84.5 cm)
34.25" (87 cm)
(Important: Hand Tighten Only!)
Figure C
Hole 3
30.75" (78 cm)
31.75" (81 cm)
32.5" (82.6 cm)
33.25" (84.5 cm)
34.25" (87 cm)
35" (89 cm)
Hole 4
31.5" (80 cm)
32.5" (82.6 cm)
33.25" (84.5 cm)
34.25" (87 cm)
34.75" (88.3 cm)
35.75" (90.8 cm)
9